About: B2 Audio Rage 3200 Monoblock Amplifier

The new B2 Audio RAGE 3200 1-channel amplifier in full bridge technology is here! With the RAGE 3200 B2 Audio introduces the new B2 Audio amplifier design with a single-sided connection front. In fact, the RAGE series, inherited features from the M and Zero series amplifiers. Low voltage and clip sensors, either on the amplifier or the bass remote are another new feature that distinguishes this amplifier series. The RAGE amplifiers all have integrated ACCU8 crossovers with bandpass configuration on all channels. 

Specifications: 

• Frequency Response: 10 Hz ~ 20 KHz (+/- 1 dB)
• Input Sensitivity: 5 ~ 0.2 V
• Crossover: 24 dB / Oct
• Low Pass Crossover 24 dB / Oct: 80 Hz ~ 20 KHz
• High Pass Crossover 12 dB / Oct: 15 Hz ~ 80 Hz
• Damping Factor: 200<
• Power Terminal gauge: 0 GA x 1
• Fuse Rating: 250 A
• Operational voltage: 9 V ~ 16 V
• Dimensions: 270 x 170 x 57 mm
• Power Handling: 
• Power @ 4 Ω (14.4V): 1 x 1100 w
• Power @ 4 Ω (13.8V): 1 x 1000 w
• Power @ 2 Ω (14.4V): 1 x 2100 w
• Power @ 2 Ω (13.8V): 1 x 2000 w
• Power @ 1 Ω (14.4V): 1 x 3200 w
• Power @ 1 Ω (13.8V): 1 x 3000 w

Note: *In order to get the full power output of the amplifier, it is crucial that your electrical system is correctly (over) dimensioned. Failure to upgrading will constrain the power output & lower the efficiency which can cause damage to the amplifier & void the warranty. This also includes ohm loads below of what is written in the manual. Read the manual thoroughly prior to installing!